Consider the following statements regarding a circular shaft (G = Shear Modulus of the material, J = Polar Moment of Area, T = Applied Torque, θ = Angle of Twist, L = Length of the shaft): Statement I: Torsional rigidity of a shaft is given by GJ. Statement II: Torsional stiffness of a shaft is given by GJ/L . Statement III: Torsional stiffness of a shaft is equal to T/θ. Which of the above statements are correct?
Asked in GPSC Graduate Engineer Trainee, Class-2, Gujarat Maritime Board (GMB) 2026
Show answer
Answer: D. I, II and III
This previous-year question came without the commission's answer key; the answer was checked by AI. Always confirm with the official key.
More GPSC Prelims previous year questions questions
- Consider the following statements: Statement I: Tendency of knock increases with advanced spark timing. Statement II: Advanced spark timing increases the pressure and temperature of the unburnt end-gas, promoting its auto-ignition. The correct option is
- In an Otto cycle, air at 15°C and 1.05 bar is compressed adiabatically until the pressure reaches 13 bar. The specific heat ratio of air is γ=1.4. Consider the following statements: Statement I: The compression ratio of the cycle is approximately 6.04. Statement II: The air-standard efficiency of the cycle is approximately 51.3%. Statement III: The compression ratio of the cycle is less than 7. Statement IV: Increasing the compression ratio increases the air-standard efficiency of an Otto cycle. Which of the above statements are correct?
- Consider the following statements regarding combustion in SI engines: Statement I: The higher the self-ignition temperature of the fuel, the longer the ignition lag. Statement II: The ignition lag is smallest for the mixture ratio that gives the maximum temperature. Statement III: The ignition lag depends on the chemical nature of the fuel. Which of the above statements are correct?
- Consider the following statements regarding diesel injection systems: Statement I: In an air injection system, fuel is injected into the cylinder by means of compressed air. Statement II: The air injection system requires an air compressor, making the system complicated and expensive. Statement III: Solid injection system is also known as airless mechanical injection. Statement IV: Modern diesel engines predominantly use the air injection system. Which of the above statements are correct?
- Consider the following statements regarding dimensionless numbers in heat transfer: Statement I: Biot number is the ratio of the internal thermal resistance of a solid to the boundary layer thermal resistance. Statement II: The Grashof number represents the ratio of viscous force to buoyancy force. Statement III: The Prandtl number is the ratio of momentum diffusivity to thermal diffusivity. Which of the above statements are correct?
- Consider the following statements regarding radiation properties: Statement I: Emissive power is the rate at which radiation is emitted by a surface per unit area. Statement II: Irradiation is the rate at which radiation is an incident upon a surface per unit area. Statement III: Radiosity is the rate at which radiation leaves a surface per unit area. Which of the above statements are correct?
- Consider the following statements regarding steam power plant: Statement I: The higher the mean temperature of heat addition, the higher is the thermal efficiency of the Rankine cycle. Statement II: Increasing the degree of superheat at constant boiler pressure increases the thermal efficiency of a conventional steam power plant. Statement III: Mean temperature of heat addition is independent of degree of superheat. Which of the above statements are correct?
- In a steam power plant, the efficiencies of the electric generator, turbine (mechanical), boiler, cycle and overall plant are 0.97, 0.95, 0.92, 0.42 and 0.33, respectively. The auxiliary efficiency of the plant is approximately