A 70 hp (1hp = 746 W) shaft compressor in a facility that operates at full load for 3000 hours a year is powered by an electric motor that has an efficiency of 90 percent. If the unit cost of electricity is Rs. 8/kWh, then the annual electricity cost of this compressor is ______.
Asked in GPSC Assistant Regional Transport Officer / Assistant Director of Transport, Class-2, Ports and Transport Department 2025
Show answer
Answer: B. Rs. 13,92,533
More GPSC Prelims previous year questions questions
- The coil on the back side of the refrigerator (a part of refrigerator) is a ______ of refrigeration system.
- A heat engine working on Carnot cycle receives heat at the rate of 80 kW from a source at 1200 K and rejects it to a sink at 300 K. The heat rejected is ______.
- A rigid tank contains 4 kg of an ideal gas at 4 atm and 127°C. Now a valve is opened, and half of mass of the gas is allowed to escape. If the final pressure in the tank is 2 atm, then the final temperature in the tank is ______.
- If the COP of the heat pump is 4.3, then the COP of the refrigerator operating between the same temperature reservoir is ______.
- Water enters a pipe at 25°C at a rate of 0.5 kg/s and is heated to 85°C. The rate of heat transfer to the water is ______. (Assume the specific heat of water as 4.2 kJ/kg K)
- The variation of temperature in a plane wall is determined to be T(x) = 120 – 60x where x is in m and T is in °C. If the thickness of the wall is 0.75 m, the temperature difference between the inner and outer surfaces of the wall is ______.
- The gauge pressure of an automobile tire is measured to be 200 kPa before a trip and 220 kPa after the trip at a location where the atmospheric pressure is 100 kPa. Assuming the volume of the tire remains constant and the air temperature before the trip is 27°C, the air temperature in the tire after the trip is ______.
- A rigid tank contains air at 500 kPa and 150°C. As a result of heat transfer to the surroundings, the temperature and pressure inside the tank drop to 65 °C and 400 kPa respectively. The boundary work done during this process is ______.