A drill depth shows a tapered hole instead of straight. The most likely reason is
Asked in APPSC (Arunachal) Question Booklet (Set-A) of Paper I and Paper II 2026
Show answer
Answer: D. drill wander due to unequal lip angles
More APPSC Prelims previous year questions questions
- A single-point tool is used for cutting a metric thread of 1.5 mm pitch. If the spindle rotates at 300 rpm, then the linear feed of the tool in mm/min is
- An M12 × 1.75 mm internal thread is to be tapped. The size of the hole to be drilled is
- In a hydraulic shaper, the cutting speed is controlled by
- The number of turns of the index crank required to cut 24 teeth gear using a 40 : 1 dividing head is
- The role of abrasive slurry in USM is
- In USM, if tool wears 0.1 mm while workpiece is machined to 1 mm depth, the tool wear ratio is
- In EDM process, in order to remove maximum metal and have minimum wear on the tool,
- Heat-Affected Zone (HAZ) in LBM can be minimized by