A prime mover running at 300 r.p.m. drives a D.C. generator at 500 r.p.m. by a belt drive. Diameter of the pulley on the outside shaft of the prime mover is 600 mm. Assuming slip of 3 %, What is the approximate diameter of generator pulley if the belt running over it is 6 mm thick ?
Asked in RPSC 23Feb 2016Question Paper for VicePrincipal/Superintendent ITI Screening Test 2012(Mechanical Engineering)VICE PRINCIPAL/SUPDT. ITI - 2012
Show answer
Answer: A. 346.7 mm
More RPSC Prelims previous year questions questions
- In a clock mechanism, hour and minute hands are connected by
- If the air screw of an aeroplane rotates clockwise when viewed from the rear and aeroplane takes a right turn, the gyroscopic effect will be
- Which of the following dynamometer is used for measuring large power along the propeller shaft of turbine
- A large uniform plate containing the hole is subjected to a uniform axial tension 'σ'. The maximum stress in the plate is
- The ratio of hoop stress to longitudinal stress in thin walled cylinder is
- The reason why a laminated spring is made up of a series of leaves is to :
- The greatest twisting moment which a shaft can resist is given by
- If the tearing efficiency of riveted joint is 75%, the ratio of diameter of rivet to the pitch is equal to