A solid circular shaft is subjected to a bending moment M and twisting moment T. What is the equivalent twisting moment Te which will produce the same maximum shear stress as the above combination? 1) M^2 + T^2 2) M+T 3) \sqrt{M^2 + T^2} 4) M-T
Asked in RPSC 02Jun 2016Question Paper for Asst. Drilling Engineer (Mines and Geology Deptt.) Screening Test- 2014ASST. DRILLING ENGINEER - 2014
Show answer
Answer: C. \sqrt{M^2 + T^2}
More RPSC Prelims previous year questions questions
- Ques # :28 The shapes of the bending moment diagram for a uniform cantilever beam carrying a uniformly distributed load over its length is:- 1) A straight line 2) A hyperbola 3) An ellipse 4) A parabola
- Ques # :29 A steel bar of 40 mm x 40 mm square cross-section is subjected to an axial compressive load of 200 kN. If the length of the bar is 2m and E = 200 GPa, the elongation of the bar will be: 1) 1.25 mm 2) 2.70 mm 3) 4.05 mm 4) 5.40 mm
- The shear stress on principal planes is :- 1) Maximum 2) Minimum 3) Zero 4) None of these
- Ques # :31 A dimensionless combination of pressure drop 'ΔP', dynamic viscosity 'μ', velocity 'V' and length 'L' is :- 1) ΔP/(V^2.L) 2) (V.L)/μ 3) ΔP/(μ.V.L) 4) (ΔP.L)/(μ.V)
- Ques # :32 The flow of a liquid at constant rate in a conically tapered pipe is classified as 1) Steady, uniform flow 2) Steady, non uniform flow 3) Unsteady, uniform flow 4) Unsteady, non uniform flow
- Ques # :34 The intensity of turbulence refers to :-
- Ques # :35 A 1000 m long pipe discharges 1 m³/sec of water with the head of 99 m at the inlet. The maximum power transmitted by pipe is (specific weight of water = 10 kN/m³)
- Ques # :36 An oil of kinematic viscosity 0.25 stokes flows through a pipe of diameter 10 cm. The flow is critical at the velocity of :