Assertion (A): If the bending moment along the length of a beam is constant, then the beam cross-section will not experience any shear stress. Reason (R): The shear force acting on the beam will be zero everywhere along the length.
Asked in APPSC (Arunachal) Question Booklet (Set-A) of Paper I and Paper II 2026
Show answer
Answer: A. Both A and R are individually true and R is the correct explanation of A
More APPSC Prelims previous year questions questions
- Assertion (A): The change in bending moment between two cross-sections of a beam is equal to the area of the shearing force diagram between the two sections. Reason (R): The change in the shearing force between two cross-sections of beam due to distributed loading is equal to the area of the load intensity diagram between the two sections.
- If the shear force acting at every section of a beam is of the same magnitude and of the same direction, then it represents a
- The compaction factor of 0.95 between partially compacted (W_p) and fully compacted (W_f) concrete indicates what level of workability in the concrete?
- In a slump test, each layer of concrete is compacted by a steel rod 60 cm long and of 16 mm diameter for 20 times. This statement is
- Assertion (A) : If the bending moment diagram is a rectangle, it indicates that the beam is loaded by a uniformly distributed moment all along the length. Reason (R) : The BMD is a representation of internal forces in the beam and not the moment applied on the beam.
- Which of the seasoning method is adopted for the rapid seasoning of timber on large scale to obtain any desired moisture content?
- If a beam is subjected to a constant bending moment along its length, then the shear force will
- Match the following : (a) Service pipe (i) Pipe connecting storage tanks to various fixtures (b) Distribution pipe (ii) Pipe used for feeding the water from the main to the building (c) Supply pipe (iii) Pipeline between stopcock and storage tank (d) Water main (iv) Pipeline intended for general use