Transformers
Guiding State PSC aspirants since 2016 50,000+ students · 1,000+ final selections Exam Calendar Results Call 9116926003
pscnotes
Pick your state

Transformers questions with answers

123 multiple-choice questions. Open any question for its answer and explanation.

  1. Which of the following is the most likely source of harmonics in a transformer?
  2. Two transformers operating in parallel will share the load depending upon their
  3. Which of the following is not a routine test on transformers?
  4. The core used in high frequency transformer is usually
  5. Primary winding of a transformer
  6. Gas is usually not liberated due to dissociation of transformer oil unless the oil temperature exceeds
  7. Which of the following parts of a transformer is visible from outside?
  8. In a transformer the resistance between its primary and secondary is
  9. Which of the following acts as a protection against high voltage surges due to lightning and switching?
  10. Two transformers are connected in parallel. These transformers do not have equal percentage impedance. This is likely to result in
  11. In a given transformer for given applied voltage, losses which remain constant irrespective of load changes are
  12. No-load current of a transformer has
  13. The transformer laminations are insulated from each other by
  14. A transformer core is laminated to
  15. Which of the following protection is normally not provided on small distribution transformers?
  16. For given applied voltage, with the increase in frequency of the applied voltage
  17. Insertion of resistance in the rotcir of an induction motor to develop a given torque
  18. Which type of winding is used in 3phase shell-type transformer?
  19. Hysteresis loss in a transformer varies as (Bmax = maximum flux density)
  20. The maximum load that a power transformer can carry is limited by its
  21. No-load on a transformer is carried out to determine
  22. A transformer can have regulation closer to zero
  23. If a transformer is switched on to a voltage more than the rated voltage
  24. During open circuit test of a transformer
  25. The no load current in a transformer lags behind the applied voltage by an angle of about