In Data Acquisition System, if in pre-amplification circuit, signal levels below a tenth of an mV is needed than the following is used :
Asked in TNPSC Industrial Safety and Health (Subject Code 515)
Show answer
Answer: C. Differential amplifier
More TNPSC Prelims previous year questions questions
- What is the bandwidth required for an F.M. signal in which the modulating frequency is 2 kHz and maximum deviation is 10 kHz?
- A linear displacement transducer (digital) normally uses
- Piezoelectric transducer cannot measure ________ pressure.
- In a transducer, the observed output deviates from the correct value by a constant factor the resulting error is called
- Calculate the sensitivity of a 200 μA meter movement which is to be used as a dc voltmeter. (A) 5kΩ/V (B) 200 kΩ/V (C) 50 kΩ/V (D) 150 kΩ/V (E) Answer not known
- A gear wheel having 60 teeth is mounted on a shaft running of 1800 rpm drives a gear having 30 teeth through two carriers 120 teeth and 60 teeth. The 30 teeth gear drives a double worm which is mounted on a shaft. Find the speed of the last shaft. (A) 900 rpm (B) 1800 rpm (C) 3600 rpm (D) 7200 rpm (E) Answer not known
- Calculate the ends per inch of the 3/60s stock part system. (A) 60 (B) 70 (C) 80 (D) 90 (E) Answer not known
- In winding machine, the traverse guide makes 50 double traverse/minute, each traverse being 30 cm. What is the velocity of yarn guide in meters per seconds (m/s) (A) 0.4 (m/s) (B) 0.416 (m/s) (C) 0.5 (m/s) (D) 0.25 (m/s) (E) Answer not known
All 17,524 TNPSC Prelims previous year questions questions →