In Non woven fabric production, high punch density typically achieved by (A) Increasing humidity in the production area (B) Decreasing the number of needles in the needle board (C) Passing the fabric through multiple needle 100 m sequence (D) Lowering the punch frequency of the 100 m (E) Answer not known
Asked in TNPSC Industrial Safety and Health (Subject Code 515)
Answer under review: our editors are checking this question. Try the other TNPSC Prelims previous year questions questions meanwhile.
More TNPSC Prelims previous year questions questions
- In non woven manufacturing, the creping process used to (i) Increase the bulk (ii) Increase the soft (iii) Decrease the extensibility (iv) Decrease the strength (A) (i) and (ii) only (B) (i) and (iii) only (C) (ii) and (iii) only (D) (iii) and (iv) only (E) Answer not known
- What is the fundamental principle in knitted fabric manufacturing?
- Assume Peirce's geometry and circular yarn of 0.5 mm diameter. A square plain woven fabric with maximum sett would have ______ crimp.
- Which of the following draft is preferred for fabric with high warp density?
- In cam shedding mechanism, the maximum number of healds can be accommodate by
- Torsion bar picking mechanism is used in
- Identify the element used to restrict width wise contraction in the warp sheet during beating-up.
- In ring spinning, drafting system is mostly inclined at an angle α =
All 17,524 TNPSC Prelims previous year questions questions →