Ques #:20 The common mode error voltage in a DVM can be eliminated by using at its input 1) a differential amplifier 2) a wide band amplifier 3) a tuned amplifier 4) a low pass filter
Asked in RPSC Vice Principal/Superintendent ITI Screening Test 2012 VPITI-Electronic-and-Communications
Show answer
Answer: A. a differential amplifier
More RPSC Prelims previous year questions questions
- Ques #:21 An OR gate may be imagined as 1) switches connected in series 2) switches connected in parallel 3) MOS transistors connected in series 4) None of these
- Ques #:22 Which of the following logic gates dissipates minimum power 1) RTL 2) TTL 3) MOS 4) ECL
- The fan out TTL logic gate is about
- Consider the following statements regarding registers and latches: 1. Registers are made of edge-triggered FFs, whereas latches are made from level-triggered FFs. 2. Registers are temporary storage devices whereas latches are not. 3. A latch employs cross-coupled feedback connections. 4. A register stores a binary word whereas a latch does not. Which of the statements given above are correct
- Consider the following shift right register : The initial contents of the 4-bit serial-in parallel-out, shift right register shown are 0110. What will be the contents of the register after 3 clock pulses are applied
- The output voltage of a 5-bit DAC that has a digital input of 11010 (Assuming 0 = 0V and 1 = +10V) is
- The 54/74164 chip is an 8-bit serial- in -parallel-output shift register. The clock is 1 MHz. The time needed to shift a 8-bit binary number into the chip is
- The essential blocks of a phase lock loop (PLL) are phase detector, amplifier,