Ques # :30 The normal move-out time of seismic reflection is directly proportional to which of the following ? 1) Offset distance 2) Square of the offset distance 3) Velocity 4) Square of the velocity
Asked in RPSC 02Jun 2016Question Paper for Junior Geophysicist (Mines and Geology Deptt.) Screening Test - 2014JUNIOR GEOPHYSICIST - 2014
Answer under review: our editors are checking this question. Try the other RPSC Prelims previous year questions questions meanwhile.
More RPSC Prelims previous year questions questions
- Ques # :31 The IP effect is observed over multi-metal sulphide body because :- 1) The body is partly above and partly below the water table 2) The resistivity of the body is very low 3) Due to presence of more than one metallic mineral 4) The path of inducing current changes from ionic to electronic and electronic to ionic
- Ques # :32 What is the width of the seismic pulse with frequency 30 Hz and seismic velocity of 3000 meter/sec? 1) 100 meters 2) 900 meters 3) 300 meters 4) 400 meters
- Ques # :33 A horizontal reflector separates the two layers with velocities 2500 meters/sec (top layer) and 3800 meter/sec (bottom layer). What is the reflection coefficient if the density of the top layer is 2.2 gm/ cm³ and that of bottom layer is 2.4 gm/cm³ ? 1) -0.248 2) +0.148 3) +0.248 4) -0.148
- Ques # :34 Which of the following is required for a seismic wave to reflect from a subsurface boundary ? 1) Velocity contrast 2) Density contrast 3) Acoustic impedance contrast 4) Temperature contrast
- Ques # :37 What is critical distance (approximate) for the interface shown at the depth of 12 meters in the following figure ? V1= 800 meter/sec h=12 meters V2 = 1800 meter/sec 1) 12 meters 2) 16 meters 3) 20 meters 4) 24 meters
- A low velocity layer with velocity V2 is sandwiched between layers with velocity V1(>V2) at the top and with velocity V3(>V2) at teh bottom. What are the velocities estimated from the time-distance plot of seismic refraction for this model?
- What is the resistivity of copper with resistance R, length L and cross sectional area A?
- The Wenner configuration with electrode spacing 'a' measures the potential difference ΔV for a current of 1 Ampere during a resistivity survey.What is the apparent resistivity for this case ?