Ques # :46 The bending stress in full length leaves of a laminated spring is 1) same as in graduated leaves 2) 50% more than that in graduated leaves 3) 50% less than that in graduated leaves 4) 25% more than that in graduated leaves
Asked in RPSC 02Jun 2016Question Paper for Asst. Engineer (Mechanical) GWD Screening Test - 2014ASST. ENGINEER - 2014
Answer under review: our editors are checking this question. Try the other RPSC Prelims previous year questions questions meanwhile.
More RPSC Prelims previous year questions questions
- A component has a cross section area of 100 mm² and section modulus of 5x10 mm³. It is subjected to an eccentric axial tensile load of 10 kN with an eccentricity of 10 mm. What will be the maximum and minimum stresses developed in the member?
- Which of the following is NOT the correct reason for using cast iron for components like machine bed, housings of gear boxes, etc.?
- Two beams of equal cross sectional area are subjected to same bending moment. The beam A is of solid circular section and the beam B is of square cross section. Which of these will be stronger in bending?
- What is the objective of tempering of steel after hardening?
- Pick the wrong statement about various theories of failure
- To take up limited mis-alignment of two coaxial shafts, which type of coupling is used?
- Which of the following constitute a lower pair?
- An inversion of four bar chain in which one link can make complete rotation while the output link oscillates is obtained when