Ques # :54 Ball bearing are made from:-
Asked in RPSC 02Jun 2016Question Paper for Asst. Drilling Engineer (Mines and Geology Deptt.) Screening Test- 2014ASST. DRILLING ENGINEER - 2014
Show answer
Answer: D. Chrome nickel steel
More RPSC Prelims previous year questions questions
- Ques # :55 Instrument used to measure the flow through open canal:-
- Ques # :56 The torque that can be transmitted safely by the spur gear tooth at zero pitch line velocity is known as:-
- Ques # :57 M 20 bolt has a shank of 50 mm length and a thread of 25 mm length. It is subjected to a tensile load of 10kN. Young's modulus of bolt material is 205000 N/mm². Dc = 0.8d. The strain energy stored in the bolt, if the shank of the bolt is turned down to root of the thread, is:-
- Ques # :58 Two plates are joined by a parallel fillet weld. The plate is subjected to a tensile load of 340 kN. The working stress in shear for weld material is 80 Mpa. The length of 15 mm weld received to resist load is:-
- Ques # :60 A steam pipe is covered with two layers of insulating materials, with the better insulating material forming the outer part. If the two layers are interchanged, the heat conducted:- 1) Will decrease 2) Will increase 3) Will remain unaffected 4) may increase or decrease depending upon the thickness of each layer
- Ques # :61 A plane wall of thickness 2L has a uniform volumetric heat source q"(W/m3). It is exposed to local ambient temperature Tα at both the ends(x=±L). The surface temperature Ts of the wall under steady-state condition (where h and k have their usual meanings) is given by: 1) Ts = Tα + q* L / h 2) Ts = Tα + q* L2 / 2k 3) Ts = Tα + q* L2 / h 4) Ts = Tα + q* L3 / 2k
- Ques # :62 A Prandtl number of a flowing fluid greater than unity indicates that hydrodynamic boundary layer thickness is:- 1) Greater than thermal boundary layer thickness 2) Equal to thermal boundary layer thickness 3) Smaller than thermal boundary layer thickness 4) Independent of thermal boundary layer thickness
- Ques # :63 For fully developed turbulent flow in a pipe with heating, the Nusselt number Nu, varies with Reynolds number Re and Prandtl number Pr as:- 1) Re 0.5 Pr1/3 2) Re 0.8 Pr0.2 3) Re 0.8 Pr0.4 4) Re 0.8 Pr0.3