Ques #: 8 The time taken to drill a hole through a 25 mm thick plate with the drill rotating at 300 rpm and moving at a feed rate of 0.25 mm/rev is:- 1) 10 sec 2) 20 sec 3) 60 sec 4) 100 sec
Asked in RPSC 02Jun 2016Question Paper for Asst. Drilling Engineer (Mines and Geology Deptt.) Screening Test- 2014ASST. DRILLING ENGINEER - 2014
Show answer
Answer: C. 60 sec
More RPSC Prelims previous year questions questions
- Ques #: 9 The method of classification of items to be adopted for spare parts inventory is : 1) ABC analysis 2) XYZ analysis 3) VED analysis 4) SDE analysis
- Ques #: 10 In rolling process, sheet of 25 mm thickness is rolled to 20 mm thickness. Roll is of diameter 600 mm and it rotates at 100 rpm. The rod strip contact length will be 1) 5 mm 2) 39 mm 3) 78 mm 4) 120 mm
- Ques #:11 Calculate the smallest punch diameter that can be designed for piercing sheet metal strip with the following data: [Crushing strength of the punch material is 1500 Mpa. Thickness of the sheet is 2mm, factor of safety is 3, and shear strength of the sheet material is 500 Mpa] 1) 2 mm 2) 6 mm 3) 8 mm 4) 24 mm
- Ques #:12 A shaft has diameter \(35_{-0.025}^{-0.009}\). The respective values of fundamental deviation and tolerance are :- 1) \(-0.025, \pm 0.008\) 2) \(-0.025, -0.008\) 3) \(-0.009, \pm 0.008\) 4) \(-0.009, 0.016\)
- Ques #:13 A taper hole is inspected using a CMM, with a probe of 2 mm diameter. At a height, Z=10 mm from the bottom, 5 points are touched and diameter of circle (not compensated for probe size) is obtained as 20 mm. Similarly, a 40 mm diameter at height Z= 40 mm, the smaller diameter (in mm) of the hole at Z=0 is 1) 13.334 2) 15.334 3) 15.442 4) 15.542
- Ques #:14 In a 2-D CAD package, clockwise circular are of radius 5,specified from P1(15,10) to P2(10,15) will have its centre at:- 1) (10,10) 2) (15,10) 3) (15,15) 4) (10,15)
- Ques #:15 In a transportation problem, there are four supply centers and five demand centers,The total quantity of supply available is greater than total demand . The number of allocations without degeneracy during an iteration is : 1) 3 2) 6 3) 9 4) 0
- Ques #:16 The length of the links of a 4-bar linkage with revolute pairs only are m, n, o and p units. Given that n>m>p>0 . Which of these links should be the fixed one, for obtaining a "double crank" mechanism? 1) Link of length m 2) Link of length n 3) Link of length o 4) Link of length p