Ques # :94 A discrepancy is :-
Asked in RPSC 02Jun 2016Question Paper for Asst. Drilling Engineer (Mines and Geology Deptt.) Screening Test- 2014ASST. DRILLING ENGINEER - 2014
Show answer
Answer: A. The difference between a measurement and true value of the quantity measured
More RPSC Prelims previous year questions questions
- Ques # :95 Which of the following is a non-contact type thermometer?
- Ques # :96 A hot wire anemometer is used to measure :-
- Ques # :97 A piezoelectric crystal can be used to measure :-
- Ques # :98 Which of the following material can bear sudden and excessive shocks better?
- Ques # :99 In petrol engine mechanism , the piston is at its dead centre position when piston:- (a) Acceleration is zero (b) Acceleration is maximum (c) Velocity is zero (d) Velocity is infinity
- Ques # :100 OC curves are used for the selection of lots by :-
- Ques # : 1 It is desirable to use Groundwater than Surface water because: 1) The temperature and chemical composition of groundwater is nearly constant 2) Groundwater storage is not seriously affected by short droughts 3) It is stored by nature through many years of recharge 4) all of these
- Ques # : 2 Groundwater development is discouraged in some areas because: 1) Underlain rocks have insufficient porosity and permeability to yield much water to wells 2) TDS content in groundwater is greater than that in surface water 3) In regions of high precipitation cost of developing wells is higher than the cost of developing small streams 4) All of these