Time taken drill a hole through a 25 mm thick plate at 300 r.p.m. at a feed rate of 0.25 mm/revolution will be
Asked in Mizoram PSC JE P&E Deptt. Mechnical Engg. Paper-II-2015. 2025
Show answer
Answer: B. 20 sec
More MPSC Prelims previous year questions questions
- 120, 101, 82, 65, 50, ?
- 7, 15, 29, 59, 117, ?
- The ratio of lateral strain to linear strain is known as
- The ratio of shearing force to cross sectional area is known as
- Modulus of rigidity is given by the ratio of
- A material which recovers fully after unloading but not instantaneously is known as
- The safe value of stress under which member subjected to reversible tensile or compressive stress will not fail is known as
- A material capable of absorbing large amount of energy is known as