Which of the following features characterize(s) 'pseudomorphism'? 1. A mineral maintains the outward crystal form of a different mineral species. 2. The chemical composition of the original mineral is preserved. 3. It can occur through the process of replacement or encrustation. Select the correct answer using the code given below:
Asked in GPSC Provisional Key (Prelim) - 25/-27 Concerned Subject 2026
Show answer
Answer: A. 1 and 3 only
This previous-year question came without the commission's answer key; the answer was checked by AI. Always confirm with the official key.
More GPSC Prelims previous year questions questions
- Consider the following statements regarding 'Solid Solution' in minerals: 1. It occurs when two or more elements substitute for each other in a specific atomic site. 2. Continuous solid solution requires the substituting ions to have a radius difference of less than 15% 3. The Plagioclase series is an example of a discontinuous solid solution series. Which of the statements given above are correct?
- Which of the following occurs in 'Biaxial' minerals but not in 'Uniaxial' minerals? 1. The presence of two optic axes. 2. The existence of three principal refractive indices (α, β, γ). 3. The display of no interference colours under crossed polars. Select the correct answer using the code given below:
- Consider the following statements regarding 'Twinning' in minerals: 1. Contact twins share a common composition plane. 2. Polysynthetic twinning is characterized by numerous parallel twin lamellae. 3. The Carlsbad twin is a common example of penetration twinning in plagioclase. Which of the statements given above are correct?
- Which of the following properties is/are used to distinguish 'olivine' from 'clinopyroxene' in thin section? 1. Olivine lacks distinct cleavage, while clinopyroxene has two good cleavages at ≈ 90°. 2. Olivine often exhibits distinctive irregular fractures. 3. Clinopyroxene typically shows lower birefringence than olivine. Select the correct answer using the code given below:
- Consider the following statements regarding the 'Silica' group: 1. Coesite and Stishovite are high-pressure polymorphs of SiO2. 2. Alpha-quartz is the high-temperature form, while Beta-quartz is the low-temperature form. 3. Opal is an amorphous, hydrated form of silica that lacks a crystalline lattice. Which of the statements given above are correct?
- Which of the following is/are the characteristic of 'zoning' in minerals? 1. It is caused by changes in the chemical environment during crystal growth. 2. It is commonly observed in plagioclase feldspars in volcanic rocks. 3. Oscillatory zoning indicates a perfectly stable equilibrium during crystallization. Select the correct answer using the code given below:
- Consider the following statements regarding 'Biaxial Interference Figures': 1. The 'melatope' represents the point where an optic axis emerges. 2. The 'isochromatic curves' represent lines of equal retardation. 3. The distance between isogyres in a centered acute bisectrix figure is proportional to the 2V angle. Which of the statements given above are correct?
- Which of the following occurs during 'Enantiotropic' polymorphism? 1. The transformation between polymorphs is reversible with changes in temperature or pressure. 2. One polymorph is stable over all temperatures and pressures until it melts. 3. The conversion usually involves a displacive transformation with minimal structural breakage. Select the correct answer using the code given below: