Which of the following statements is true for mating parts allowance?
Asked in GPSC Assistant Regional Transport Officer / Assistant Director of Transport, Class-2, Ports and Transport Department 2025
Show answer
Answer: A. If allowance is positive, then it is minimum clearance and if allowance is negative, then it is maximum interference.
More GPSC Prelims previous year questions questions
- The centroid is located vertically at a distance of ______ from the top line of the “T” section as shown in the figure given below.
- The centroid of a semicircle (radius = r) is located at a distance of ______ along the vertical radius from its center
- A triangular section has 5 cm base and 6 cm height. The moment of inertia of the section about the base is ______.
- Polar moment of inertia for an area with respect to an axis perpendicular to the plane is equal to ______.
- Identify the force system from the figure given below. F₁, F₂, F₃ are representing the forces.
- Two forces of magnitude P = 4 N and Q = 3 N are acting at a point O as shown in the figure given below. If the angle between the forces is 60°, then the magnitude of the resultant force ‘R’ is approximately ______.
- What are the conditions for the equilibrium of a two-dimensional force system? i. Summation of forces in x direction is equal to zero ii. Summation of forces in y direction is equal to zero iii. Moment about any point is equal to zero
- Three parallel forces like 100 N, 200 N and 300 N are acting at points A, B and C respectively as shown in the figure given below. The distances are AB = 30 cm and BC = 40 cm. The resultant force is ‘R’. The value of ‘x’ is ______.