While creating the block diagram of control system in NC machines, the ______ symbol is used as amplifier representation. (A) Circle (B) Triangle (C) Rectangle (D) Arch (E) Answer not known
Asked in TNPSC Industrial Safety and Health (Subject Code 515)
Answer under review: our editors are checking this question. Try the other TNPSC Prelims previous year questions questions meanwhile.
More TNPSC Prelims previous year questions questions
- The degrees of freedom of a system having two components, number of phases as three and having temperature as the only external variable is (A) 1 (B) 2 (C) 0 (D) –1 (E) Answer not known
- An ion dislodged from the lattice into an interstitial site is called (A) Interstitially (B) Schottky imperfections (C) Frenkel defect (D) Vacancy (E) Answer not known
- For contactless body temperature measurement, advanced thermometers are used. It works on the principle/type/basis of
- Electrolux refrigerator is a vapour absorption system that operates with
- The effect of superheating suction vapours in vapour compression refrigeration system using R – 12 theoretically results in __________ of refrigeration capacity of the system.
- Equivalence ratio is
- A carnot engine does 0.27 kJ of work per cycle, while receiving 0.64 kJ of heat at 260 °C. Determine the temperature of the sink at which heat is rejected.
- A house has a heat requirement of 2 lakh kJ/h in winter for heating. Heat pump is used to absorb heat from cold air outside in winter and send heat to house. Work required to operate the heat pump is 28000 kJ/h. Same amount of heat is to absorbed from this house during summer for cooling the house using similar work input. The lop of heat pump and refrigerator for the above mode of operation is
All 17,524 TNPSC Prelims previous year questions questions →