With the introduction of PI controller in a control system, pick the correct effect produced.
Asked in APSC INSTRUMENTATION
Show answer
Answer: C. Overshoot increases
More APSC Prelims previous year questions questions
- If the input AC is 10 V rms, the maximum voltage that will appear across the diode of an HWR (half-wave rectifier) with a capacitor filter is
- Which of the following has the least power dissipation?
- What is quiescent point or Q-point?
- Ripple factor determines how well an HWR can convert AC voltage to DC voltage. Ripple factor of an HWR is
- Which amplifier circuit can be used as a current buffer circuit?
- Thermal runaway is not possible in FET because as the temperature of FET increases
- Consider the following statements : P : JFET is biased to operate in active region. Q : MOSFET is biased to operate in saturation region. Select the correct answer.
- For an OPAMP shown in Fig. 10, the bias currents are Ib1 = 450 nA and Ib2 = 350 nA. The values of the input bias current (Ib) and the input offset current (If) are