A long rod of uniform rectangular section is bent to form a circular arc. The thickness of the section is t, length of the rod is l and the displacement of the midpoint is d (where d ≪ l). The maximum longitudinal strain developed in the rod is:
Asked in GPSC Graduate Engineer Trainee, Class-2, Gujarat Maritime Board (GMB) 2026
Show answer
Answer: B. 8 td/l2
This previous-year question came without the commission's answer key; the answer was checked by AI. Always confirm with the official key.
More GPSC Prelims previous year questions questions
- Consider the following statements for a cantilever beam carrying a point load W at the free end: Statement I: Maximum bending moment occurs at the fixed end. Statement II: Maximum deflection occurs at the free end. Statement III: Slope at the free end is WL2/3E . Statement IV: Deflection at the free end is WL3/2EI . Which of the above statements are correct?
- Consider the following statements regarding a circular shaft (G = Shear Modulus of the material, J = Polar Moment of Area, T = Applied Torque, θ = Angle of Twist, L = Length of the shaft): Statement I: Torsional rigidity of a shaft is given by GJ. Statement II: Torsional stiffness of a shaft is given by GJ/L . Statement III: Torsional stiffness of a shaft is equal to T/θ. Which of the above statements are correct?
- Consider the following statements: Statement I: Tendency of knock increases with advanced spark timing. Statement II: Advanced spark timing increases the pressure and temperature of the unburnt end-gas, promoting its auto-ignition. The correct option is
- In an Otto cycle, air at 15°C and 1.05 bar is compressed adiabatically until the pressure reaches 13 bar. The specific heat ratio of air is γ=1.4. Consider the following statements: Statement I: The compression ratio of the cycle is approximately 6.04. Statement II: The air-standard efficiency of the cycle is approximately 51.3%. Statement III: The compression ratio of the cycle is less than 7. Statement IV: Increasing the compression ratio increases the air-standard efficiency of an Otto cycle. Which of the above statements are correct?
- Consider the following statements regarding combustion in SI engines: Statement I: The higher the self-ignition temperature of the fuel, the longer the ignition lag. Statement II: The ignition lag is smallest for the mixture ratio that gives the maximum temperature. Statement III: The ignition lag depends on the chemical nature of the fuel. Which of the above statements are correct?
- Consider the following statements regarding diesel injection systems: Statement I: In an air injection system, fuel is injected into the cylinder by means of compressed air. Statement II: The air injection system requires an air compressor, making the system complicated and expensive. Statement III: Solid injection system is also known as airless mechanical injection. Statement IV: Modern diesel engines predominantly use the air injection system. Which of the above statements are correct?
- Consider the following statements regarding dimensionless numbers in heat transfer: Statement I: Biot number is the ratio of the internal thermal resistance of a solid to the boundary layer thermal resistance. Statement II: The Grashof number represents the ratio of viscous force to buoyancy force. Statement III: The Prandtl number is the ratio of momentum diffusivity to thermal diffusivity. Which of the above statements are correct?
- Consider the following statements regarding radiation properties: Statement I: Emissive power is the rate at which radiation is emitted by a surface per unit area. Statement II: Irradiation is the rate at which radiation is an incident upon a surface per unit area. Statement III: Radiosity is the rate at which radiation leaves a surface per unit area. Which of the above statements are correct?