A logic chip used in a computer dissipates 4 W of power in an environment at 25°C and has a heat transfer surface area of 0.5 cm². If the heat transfer from the surface is uniform, then the heat flux on the surface of the chip in kW/m² is ______.
Asked in GPSC Assistant Regional Transport Officer / Assistant Director of Transport, Class-2, Ports and Transport Department 2025
Show answer
Answer: C. 8 kW/m²
More GPSC Prelims previous year questions questions
- The body temperature of a 60 kg runner increases from 37°C to 39°C while running a 100 meter race. If the average specific heat of the body is 3.6 kJ/kg K, then the increase in thermal energy (kJ) of the body is ______.
- A 70 hp (1hp = 746 W) shaft compressor in a facility that operates at full load for 3000 hours a year is powered by an electric motor that has an efficiency of 90 percent. If the unit cost of electricity is Rs. 8/kWh, then the annual electricity cost of this compressor is ______.
- The coil on the back side of the refrigerator (a part of refrigerator) is a ______ of refrigeration system.
- A heat engine working on Carnot cycle receives heat at the rate of 80 kW from a source at 1200 K and rejects it to a sink at 300 K. The heat rejected is ______.
- A rigid tank contains 4 kg of an ideal gas at 4 atm and 127°C. Now a valve is opened, and half of mass of the gas is allowed to escape. If the final pressure in the tank is 2 atm, then the final temperature in the tank is ______.
- If the COP of the heat pump is 4.3, then the COP of the refrigerator operating between the same temperature reservoir is ______.
- Water enters a pipe at 25°C at a rate of 0.5 kg/s and is heated to 85°C. The rate of heat transfer to the water is ______. (Assume the specific heat of water as 4.2 kJ/kg K)
- The variation of temperature in a plane wall is determined to be T(x) = 120 – 60x where x is in m and T is in °C. If the thickness of the wall is 0.75 m, the temperature difference between the inner and outer surfaces of the wall is ______.