A single-phase full-wave mid-point thyristor converter uses a 230/200 V transformer with centre tap on the secondary side (100–0–100 V). The Peak Inverse Voltage (PIV) per thyristor is
Asked in APPSC (Arunachal) Question Booklet (Set-A) of Paper I and Paper II 2026
Show answer
Answer: B. 282.8 V
More APPSC Prelims previous year questions questions
- Potential transformers are used to measure
- In a hydroelectric power station, the function of the surge tank is to
- A voltage waveform is given by v(t) = [2√2 + 2sin(ωt) − 2sin(3ωt)] volts. This voltage is measured using a moving-coil voltmeter (reading V1) and a moving-iron voltmeter (reading V2). Then V1 and V2 values respectively are
- In a DC shunt motor, the torque is proportional to
- Overhead charges in an electrical estimate include (i) office rent and administrative expenses (ii) labour wages for wiring (iii) depreciation of tools and equipment (iv) cost of transportation of materials (v) contractor's profit From the above, the correct answer is [A] (i), (iii) and (iv) only [B] (i), (ii) and (iv) only [C] (i), (iii) and (v) only [D] (ii), (iii) and (iv) only
- Energy consumed by a domestic consumer is measured in [A] kVA [B] kVArh [C] kWh [D] watt
- Hysteresis loss in magnetic materials is proportional to [A] permeability [B] resistivity [C] slope of B–H curve [D] area of B–H curve
- A winding is distributed in the slots along the air-gap periphery (i) to add mechanical strength to the winding (ii) to reduce the amount of conductor material required (iii) to reduce the harmonics in the generated e.m.f. (iv) to reduce the size of the machine (v) for full utilization of iron and conductor materials From the above, the correct answer is [A] (i), (iii), (iv) and (v) only [B] (i), (ii), (iv) and (v) only [C] (i), (ii), (iii) and (v) only [D] (i), (iii) and (v) only