A winding is distributed in the slots along the air-gap periphery (i) to add mechanical strength to the winding (ii) to reduce the amount of conductor material required (iii) to reduce the harmonics in the generated e.m.f. (iv) to reduce the size of the machine (v) for full utilization of iron and conductor materials From the above, the correct answer is [A] (i), (iii), (iv) and (v) only [B] (i), (ii), (iv) and (v) only [C] (i), (ii), (iii) and (v) only [D] (i), (iii) and (v) only
Asked in APPSC (Arunachal) Question Booklet (Set-A) of Paper I and Paper II 2026
Show answer
Answer: D. (i), (iii) and (v) only
More APPSC Prelims previous year questions questions
- Above the Curie temperature, a ferromagnetic material [A] becomes ferrimagnetic [B] becomes paramagnetic [C] becomes diamagnetic [D] remains ferromagnetic
- Which one of the following electrodes is used for pipe earthing? [A] Hollow GI rod [B] Solid steel rod [C] Solid GI rod [D] Solid copper rod
- In rural LT distribution systems, earthing is required for (i) transformer neutral point (ii) distribution poles (iii) consumer appliance metal bodies (iv) phase conductor (v) street-light poles The correct statements are [A] (i), (ii), (iii) and (v) only [B] (ii), (iii) and (iv) only [C] (i), (iii) and (iv) only [D] (i), (iv) and (v) only
- Which among the following devices is the most suited for high-frequency applications? [A] BJT [B] IGBT [C] MOSFET [D] SCR
- In a synchronous motor, the damper winding (i) provides starting torque (ii) reduces oscillations in rotor speed (iii) supplies field current during steady state (iv) acts as squirrel-cage during starting (v) causes the motor to run above synchronous speed From the above, the correct statements are [A] (i), (iii) and (v) only [B] (ii), (iii) and (iv) only [C] (i), (ii) and (v) only [D] (i), (ii) and (iv) only
- The sag of an overhead line is inversely proportional to [A] span length [B] weight of the conductor [C] square of span length [D] tension in the conductor
- The working principle of a Megger is based on [A] Ohm’s law [B] DC permanent magnet moving coil [C] generator action (hand-driven) [D] thermal effect
- Turn-on time for an SCR is 10 µsec . If an inductance is inserted in the anode circuit, then the turn-on time will be [A] 10 µsec [B] 5 µsec [C] more than 10 µsec [D] less than 10 µsec