In a synchronous motor, the damper winding (i) provides starting torque (ii) reduces oscillations in rotor speed (iii) supplies field current during steady state (iv) acts as squirrel-cage during starting (v) causes the motor to run above synchronous speed From the above, the correct statements are [A] (i), (iii) and (v) only [B] (ii), (iii) and (iv) only [C] (i), (ii) and (v) only [D] (i), (ii) and (iv) only
Asked in APPSC (Arunachal) Question Booklet (Set-A) of Paper I and Paper II 2026
Show answer
Answer: D. (i), (ii) and (iv) only
More APPSC Prelims previous year questions questions
- The sag of an overhead line is inversely proportional to [A] span length [B] weight of the conductor [C] square of span length [D] tension in the conductor
- The working principle of a Megger is based on [A] Ohm’s law [B] DC permanent magnet moving coil [C] generator action (hand-driven) [D] thermal effect
- Turn-on time for an SCR is 10 µsec . If an inductance is inserted in the anode circuit, then the turn-on time will be [A] 10 µsec [B] 5 µsec [C] more than 10 µsec [D] less than 10 µsec
- Phase splitting is achieved in single-phase induction motors with the help of [A] inductors [B] capacitors [C] resistors [D] diodes
- Double-field revolving theory states that a pulsating field is equivalent to [A] two unequal rotating fields [B] two stationary fields [C] two equal fields rotating in opposite directions [D] one rotating and one stationary field
- A 200 V shunt DC motor runs at a speed where the back e.m.f. is 180 V. Armature resistance (including brushes contact) is 0.4Ω. The armature current at this operating point is [A] 100 A [B] 50 A [C] 150 A [D] 500 A
- A series RLC circuit has quality factor Q = 25 at a resonant frequency of 5 kHz. The bandwidth of the circuit is [A] 200 Hz [B] 100 Hz [C] 50 Hz [D] 5000 Hz
- In a domestic wiring plan, the main factor for selecting cable size is