During tensile test on a specimen of 1 cm2 cross-section, maximum load observed was 80 KN and area of cross-section at neck was 0.5 cm2 . U.T.S. of the specimen is :
Asked in RPSC 23Feb 2016Question Paper for VicePrincipal/Superintendent ITI Screening Test 2012(Mechanical Engineering)VICE PRINCIPAL/SUPDT. ITI - 2012
Show answer
Answer: B. 800 MPa
More RPSC Prelims previous year questions questions
- In a simply supported beam of length L with a triangular load W varying from zero at one end and to the maximum value at the other end, the maximum bending moment is:
- Two wires of different materials but of same diameter are connected end to end and a force is applied which stretches them by 1 cm. The two wires will have the
- Maximum principal stress theory is used for
- The problem of ' hunting ' of a centrifugal governor becomes very acute when the governor becomes :
- Pitch point on cam is
- A prime mover running at 300 r.p.m. drives a D.C. generator at 500 r.p.m. by a belt drive. Diameter of the pulley on the outside shaft of the prime mover is 600 mm. Assuming slip of 3 %, What is the approximate diameter of generator pulley if the belt running over it is 6 mm thick ?
- In a clock mechanism, hour and minute hands are connected by
- If the air screw of an aeroplane rotates clockwise when viewed from the rear and aeroplane takes a right turn, the gyroscopic effect will be