The simplified approach assumes that the air gap power is roughly equivalent to the shaft power for direct calculation of rotor losses, neglecting the contribution of mechanical losses to the total power developed by the rotor.
In case of 3-phase induction motor, shaft power is 2700 W and mechanical losses are 180 W. At a slip of 4%, the rotor ohmic losses are
Asked in GS&EI ElectEngg 14 2024 1601 2025 · Topic: Electric Current (Electrical Power and Energy, Joule heating effect)
More Physics questions
- A 1-phase half-wave rectifier is used to supply to a load of impedance $8\Omega$ from 220 V, 50 Hz AC supply at a firing angle of $60^\circ$. The effective value of voltage is
- The power is transmitted through a transmission line of impedance (r + jx) at equal voltage at both ends. The maximum power can be transferred under the steady-state condition if
- A DC motor develops the maximum mechanical power when the armature is such that
- A DC motor develops the maximum mechanical power when the back e.m.f. is such that - If the question has multiple statements, format using ... - For Assertion/Reason, retain 'Statement-I' and 'Statement-II' clearly. - For matching pairs, use HTML
- In electric bulb, the gas used is
- If the speed of a moving magnet inside a coil increases, the electric current in the coil
- A resistor of 10 $\Omega$ connected across a cell of emf 12 V, draws the current of 1.1 A. Find the internal resistance of the cell.
- An electric circuit is given below. V₁ = 1 V and Resistance R = 1000 Ω. The current through the resistance R is very close to 1 mA and the voltage across point A and B, VAB = 1 V. Now the circuit is changed to : where value of V₂ = 5 V. The internal resistances of both the batteries are 0.1 Ω. The current through the resistance R is about :