HORTICULTURE DEVELOPMENT OF‐ FICER(HDO) -2015 In India, the standard voltage for domestic electricity supply is 220 Volts (V), and the frequency is 50 Hertz (Hz). This is the standard for most electrical appliances used in households. Other countries may have different standards (e.g., 110-120 V, 60 Hz in North America).
In India, distribution of electricity for domestic purpose is done in the form of— [A] 220 V; 50 Hz [B] 110 V; 60 Hz [C] 220 V; 60 Hz [D] 110 V; 50 Hz
Asked in HORTICULTURE DEVELOPMENT OF‐ FICER(HDO) 2015 · Topic: Electric Current (Electrical Power and Energy, Joule heating effect)
More Physics questions
- The current waveform, as shown in Fig. 3, is applied in a pure resistor 10 $\Omega$ (ten ohms). The power dissipated in the resistor is
- An alternator is delivering power to a balanced load at unity power factor. The phase angle between the line voltage and the line current is
- If the readings of two wattmeters are equal and positive in the two-wattmeter method, the load power factor in a balanced 3-phase, 3-wire circuit will be
- A 200 V/100 V, 50 Hz transformer is to be excited at 40 Hz from 100 V side. For the excitation current to be same, the applied voltage should be
- In case of 3-phase induction motor, shaft power is 2700 W and mechanical losses are 180 W. At a slip of 4%, the rotor ohmic losses are
- A 1-phase half-wave rectifier is used to supply to a load of impedance $8\Omega$ from 220 V, 50 Hz AC supply at a firing angle of $60^\circ$. The effective value of voltage is
- The power is transmitted through a transmission line of impedance (r + jx) at equal voltage at both ends. The maximum power can be transferred under the steady-state condition if
- A DC motor develops the maximum mechanical power when the armature is such that