Knurling operation on lathe is used for
Asked in APPSC (Arunachal) Question Booklet (Set-A) of Paper I and Paper II 2026
Show answer
Answer: C. producing rough surface on workpiece for gripping
More APPSC Prelims previous year questions questions
- Which tool-holding feature is found only in turret lathe and not in centre lathe?
- While cutting threads on a lathe using a single-point tool, the feed direction is
- A drill depth shows a tapered hole instead of straight. The most likely reason is
- A single-point tool is used for cutting a metric thread of 1.5 mm pitch. If the spindle rotates at 300 rpm, then the linear feed of the tool in mm/min is
- An M12 × 1.75 mm internal thread is to be tapped. The size of the hole to be drilled is
- In a hydraulic shaper, the cutting speed is controlled by
- The number of turns of the index crank required to cut 24 teeth gear using a 40 : 1 dividing head is
- The role of abrasive slurry in USM is