Pick the wrong statement about the Kaplan turbine:
Asked in RPSC 02Jun 2016Question Paper for Asst. Engineer (Mechanical) GWD Screening Test - 2014ASST. ENGINEER - 2014
Answer under review: our editors are checking this question. Try the other RPSC Prelims previous year questions questions meanwhile.
More RPSC Prelims previous year questions questions
- A turbine develops 100 kW at a head of 25 m. What will be the power output of the same turbine when the head is reduced to 16 m?
- Which of the following turbines is more efficient at highly part load (upto 20-25% of full load)?
- A turbine is working under a head of 20 m. It has been installed at a power plant where the atmospheric pressure is 10 m of water and vapour pressure is 0.20 m of water. If the Thoma’s cavitation factor is 0.25, what can be the maximum height of the discharge end of the runner from the tail race?
- In which of the following types of impeller blades or vanes, theoretically, the head remains constant with varying discharge?
- Which of the following is a wrong statement about the effect of inertia of reciprocating parts in a reciprocating pump?
- Ques # :20 Axial flow pumps are suitable for 1) Large discharge with low head 2) Large discharge with high head 3) Low discharge with low head 4) Low discharge with high head
- Ques # :21 A heat flux of 40 kW/m² is passing through a plate of thickness 0.2 m and thermal conductivity 100 W/m.K. If the temperature of the hot side is 100°C, what will be the temperature of the cooler side? 1) 20°C 2) 40°C 3) 10°C 4) 0°C
- Ques # :22 A 0.6 m thick wall is made of a material with thermal conductivity of 1.2 W/m.K . This wall is to be insulated with a material of thermal conductivity 0.2 W/m.K so that the heat loss per m² area of the wall does not exceed 1200 W. If the inner and outer temperatures of the composite wall are 930°C and 30°C respectively, determine the thickness of the insulation required? 1) 7.5 cm 2) 10 cm 3) 5 cm 4) None of these