Which of the following is a wrong statement about the effect of inertia of reciprocating parts in a reciprocating pump?
Asked in RPSC 02Jun 2016Question Paper for Asst. Engineer (Mechanical) GWD Screening Test - 2014ASST. ENGINEER - 2014
Answer under review: our editors are checking this question. Try the other RPSC Prelims previous year questions questions meanwhile.
More RPSC Prelims previous year questions questions
- Ques # :20 Axial flow pumps are suitable for 1) Large discharge with low head 2) Large discharge with high head 3) Low discharge with low head 4) Low discharge with high head
- Ques # :21 A heat flux of 40 kW/m² is passing through a plate of thickness 0.2 m and thermal conductivity 100 W/m.K. If the temperature of the hot side is 100°C, what will be the temperature of the cooler side? 1) 20°C 2) 40°C 3) 10°C 4) 0°C
- Ques # :22 A 0.6 m thick wall is made of a material with thermal conductivity of 1.2 W/m.K . This wall is to be insulated with a material of thermal conductivity 0.2 W/m.K so that the heat loss per m² area of the wall does not exceed 1200 W. If the inner and outer temperatures of the composite wall are 930°C and 30°C respectively, determine the thickness of the insulation required? 1) 7.5 cm 2) 10 cm 3) 5 cm 4) None of these
- Ques # :23 A pipe of external diameter of 20 mm is carrying hot fluid. It is required to provide a lagging of insulating material of thermal conductivity 0.1 W/m.K to reduce the heat loss from the pipe. The heat transfer coefficient with the ambient air is assumed to remain same at 10 W/m².K with or without the lagging. Pick the correct statement: 1) The insulation will increase heat loss in this case. 2) Any thickness of insulation will reduce heat loss. 3) The heat loss will be reduced only if the thickness of insulation is more than the critical thickness of insulation. 4) For reducing heat loss, the thickness of insulation will have to be less than critical thickness.
- Ques # :24 The condition for heat dissipation in a parabolic fin to be independent of the distance from the base of the fin is (where δ is the thickness of the fin, b is the width of the fin at the base, L is the length of the fin and Bi is the Biot number) 1) δ/2 / L = Bi/2 2) δ/2 / L = √(Bi/2) 3) δ/2 / b = √(Bi/2) 4) b / L = √Bi
- Ques # :25 The effectiveness of an infinitely long rectangular fin is NOT increased by 1) increasing thermal conductivity of the fin material 2) increasing heat transfer coefficient 3) decreasing heat transfer coefficient 4) decreasing area of cross section of the fin
- Ques # :26 The hydrodynamic and thermal boundary layers will have equal thickness when 1) Prandtl Number = 1 2) Nusselt Number = 1 3) Prandtl Number = Nusselt Number for any Prandtl Number 4) Prandtl Number = 10
- Ques # :27 For free convection in laminar region on vertical plates, the correlation is given by (Nu = Nusselt Number, Pr = Prandtl Number and Gr = Grashof Number): 1) Nu = 0.13 (Gr.Pr) 2) Nu = 0.59(Gr.Pr)^0.25 3) Nu = 0.15(Gr.Pr)^0.33 4) Nu = 0.27(Gr.Pr)^0.25