Ques # :26 The hydrodynamic and thermal boundary layers will have equal thickness when 1) Prandtl Number = 1 2) Nusselt Number = 1 3) Prandtl Number = Nusselt Number for any Prandtl Number 4) Prandtl Number = 10
Asked in RPSC 02Jun 2016Question Paper for Asst. Engineer (Mechanical) GWD Screening Test - 2014ASST. ENGINEER - 2014
Answer under review: our editors are checking this question. Try the other RPSC Prelims previous year questions questions meanwhile.
More RPSC Prelims previous year questions questions
- Ques # :27 For free convection in laminar region on vertical plates, the correlation is given by (Nu = Nusselt Number, Pr = Prandtl Number and Gr = Grashof Number): 1) Nu = 0.13 (Gr.Pr) 2) Nu = 0.59(Gr.Pr)^0.25 3) Nu = 0.15(Gr.Pr)^0.33 4) Nu = 0.27(Gr.Pr)^0.25
- Ques # :28 Prandtl number is the ratio of 1) kinematic viscosity to thermal diffusivity 2) inertia force to viscous force 3) buoyant force to viscous force 4) None of these
- Ques # :30 In a counter flow heat exchanger, the thermal capacities of both the hot and cold fluids are the same. If NTU of the heat exchanger is 1, then the effectiveness of the heat exchanger is 1) 0.5 2) 2 3) 0.75 4) None of these
- Ques # :31 Cylindrical parabolic solar concentrators can give temperatures in the range of 1) less than 50°C 2) 50°C to 100°C 3) 100°C to 200°C 4) 300°C to 400°C
- Ques # :32 What is the theoretical cycle on which the SI engines work? 1) Otto cycle 2) Diesel cycle 3) Ericson cycle 4) Carnot cycle
- Ques # :33 Which of the following is associated with the valve operating mechanism? 1) Gudgeon pin 2) Crown 3) Tappet 4) Distributor
- Ques # :34 Pick the wrong statement about CI engines: 1) They operate at higher compression ratio. 2) The charge sucked in suction stroke consists of air only. 3) They have lower thermal efficiency than SI engines of comparable size. 4) They are more suitable for two-stroke operation.
- Ques # :35 Consider the following statements about SI engines: (a) The air is sucked in the suction stroke and fuel is injected into the cylinder to obtain a homogenous mixture of air and fuel. (b) A homogeneous mixture of air and fuel is prepared externally and sucked in the cylinder during suction stroke. (c) Ignition is by a spark plug exactly at the end of compression stroke. (d) Ignition is by a spark plug little before the end of the compression stroke. Which of the above statement(s) are correct? 1) Both (a) and (c) 2) Both (b) and (c) 3) (a), (b) and (c) 4) Both (b) and (d)