Ques # :30 In a counter flow heat exchanger, the thermal capacities of both the hot and cold fluids are the same. If NTU of the heat exchanger is 1, then the effectiveness of the heat exchanger is 1) 0.5 2) 2 3) 0.75 4) None of these
Asked in RPSC 02Jun 2016Question Paper for Asst. Engineer (Mechanical) GWD Screening Test - 2014ASST. ENGINEER - 2014
Answer under review: our editors are checking this question. Try the other RPSC Prelims previous year questions questions meanwhile.
More RPSC Prelims previous year questions questions
- Ques # :31 Cylindrical parabolic solar concentrators can give temperatures in the range of 1) less than 50°C 2) 50°C to 100°C 3) 100°C to 200°C 4) 300°C to 400°C
- Ques # :32 What is the theoretical cycle on which the SI engines work? 1) Otto cycle 2) Diesel cycle 3) Ericson cycle 4) Carnot cycle
- Ques # :33 Which of the following is associated with the valve operating mechanism? 1) Gudgeon pin 2) Crown 3) Tappet 4) Distributor
- Ques # :34 Pick the wrong statement about CI engines: 1) They operate at higher compression ratio. 2) The charge sucked in suction stroke consists of air only. 3) They have lower thermal efficiency than SI engines of comparable size. 4) They are more suitable for two-stroke operation.
- Ques # :35 Consider the following statements about SI engines: (a) The air is sucked in the suction stroke and fuel is injected into the cylinder to obtain a homogenous mixture of air and fuel. (b) A homogeneous mixture of air and fuel is prepared externally and sucked in the cylinder during suction stroke. (c) Ignition is by a spark plug exactly at the end of compression stroke. (d) Ignition is by a spark plug little before the end of the compression stroke. Which of the above statement(s) are correct? 1) Both (a) and (c) 2) Both (b) and (c) 3) (a), (b) and (c) 4) Both (b) and (d)
- Ques # :37 Which of the following statement about two-stroke engines is wrong? 1) Valves are absent. 2) The cycle is completed in two strokes or one revolution of crankshaft. 3) Lighter than a four-stroke engine of same power. 4) Due to absence of valves, a complex mechanism for admission of charge and discharge of burnt gases is required.
- Ques # :38 Which of the following is NOT a disadvantage of two stroke engines as compared to four stroke engines? 1) More cooling requirement 2) Heavier flywheel required 3) More wear and tear 4) Lower thermal efficiency
- Ques # :39 Which of the following cost is not considered in basic EOQ Model ? 1) Ordering Cost 2) Stockout Cost 3) Holding Cost 4) None of these