Ques # :34 Pick the wrong statement about CI engines: 1) They operate at higher compression ratio. 2) The charge sucked in suction stroke consists of air only. 3) They have lower thermal efficiency than SI engines of comparable size. 4) They are more suitable for two-stroke operation.
Asked in RPSC 02Jun 2016Question Paper for Asst. Engineer (Mechanical) GWD Screening Test - 2014ASST. ENGINEER - 2014
Answer under review: our editors are checking this question. Try the other RPSC Prelims previous year questions questions meanwhile.
More RPSC Prelims previous year questions questions
- Ques # :35 Consider the following statements about SI engines: (a) The air is sucked in the suction stroke and fuel is injected into the cylinder to obtain a homogenous mixture of air and fuel. (b) A homogeneous mixture of air and fuel is prepared externally and sucked in the cylinder during suction stroke. (c) Ignition is by a spark plug exactly at the end of compression stroke. (d) Ignition is by a spark plug little before the end of the compression stroke. Which of the above statement(s) are correct? 1) Both (a) and (c) 2) Both (b) and (c) 3) (a), (b) and (c) 4) Both (b) and (d)
- Ques # :37 Which of the following statement about two-stroke engines is wrong? 1) Valves are absent. 2) The cycle is completed in two strokes or one revolution of crankshaft. 3) Lighter than a four-stroke engine of same power. 4) Due to absence of valves, a complex mechanism for admission of charge and discharge of burnt gases is required.
- Ques # :38 Which of the following is NOT a disadvantage of two stroke engines as compared to four stroke engines? 1) More cooling requirement 2) Heavier flywheel required 3) More wear and tear 4) Lower thermal efficiency
- Ques # :39 Which of the following cost is not considered in basic EOQ Model ? 1) Ordering Cost 2) Stockout Cost 3) Holding Cost 4) None of these
- Ques # :40 For a diesel engine, the maximum efficiency occurs at 1) very low loads 2) around 50% load 3) around 80% load 4) full load
- Ques # :41 Which of the following will reduce knocking in diesel engines? 1) High compression ratio and short delay period of fuel. 2) High compression ratio and long delay period of fuel. 3) Low compression ratio and short delay period of fuel. 4) Low compression ratio and long delay period of fuel.
- Ques # :42 A cylinder of internal diameter 200 mm is subjected to internal pressure of 15 MPa. Determine the thickness of the cylinder if the material has a yield strength of 300 MPa. Take Factor of safety=2. 1) 10 mm 2) 5 mm 3) 7.5 mm 4) None of these
- Ques # :43 A knuckle joint with a fork of thickness of each eye as 10 mm and the outside diameter as 20 mm is subjected to a load of 15 kN. The diameter of the pin is 10 mm. What will be the magnitude of tensile stress in the fork? 1) 100 MPa 2) 75 MPa 3) 50 MPa 4) None of these