Ques # :38 Which of the following is NOT a disadvantage of two stroke engines as compared to four stroke engines? 1) More cooling requirement 2) Heavier flywheel required 3) More wear and tear 4) Lower thermal efficiency
Asked in RPSC 02Jun 2016Question Paper for Asst. Engineer (Mechanical) GWD Screening Test - 2014ASST. ENGINEER - 2014
Answer under review: our editors are checking this question. Try the other RPSC Prelims previous year questions questions meanwhile.
More RPSC Prelims previous year questions questions
- Ques # :39 Which of the following cost is not considered in basic EOQ Model ? 1) Ordering Cost 2) Stockout Cost 3) Holding Cost 4) None of these
- Ques # :40 For a diesel engine, the maximum efficiency occurs at 1) very low loads 2) around 50% load 3) around 80% load 4) full load
- Ques # :41 Which of the following will reduce knocking in diesel engines? 1) High compression ratio and short delay period of fuel. 2) High compression ratio and long delay period of fuel. 3) Low compression ratio and short delay period of fuel. 4) Low compression ratio and long delay period of fuel.
- Ques # :42 A cylinder of internal diameter 200 mm is subjected to internal pressure of 15 MPa. Determine the thickness of the cylinder if the material has a yield strength of 300 MPa. Take Factor of safety=2. 1) 10 mm 2) 5 mm 3) 7.5 mm 4) None of these
- Ques # :43 A knuckle joint with a fork of thickness of each eye as 10 mm and the outside diameter as 20 mm is subjected to a load of 15 kN. The diameter of the pin is 10 mm. What will be the magnitude of tensile stress in the fork? 1) 100 MPa 2) 75 MPa 3) 50 MPa 4) None of these
- Ques # :44 The size factor is employed to find out the endurance limit of a part from the endurance limit of the material (as determined from the standard rotating beam specimen). For sizes greater than 50 mm, this factor is 1) 0.85 2) 0.75 3) 0.9 4) 1.25
- Ques # :45 The shock and fatigue factors used in the design of shafts as per ASME for the case of gradually applied load are respectively 1) 1.0 and 1.0 2) 1.0 and 1.5 3) 1.25 and 1.0 4) 1.5 and 1.0
- Ques # :46 The bending stress in full length leaves of a laminated spring is 1) same as in graduated leaves 2) 50% more than that in graduated leaves 3) 50% less than that in graduated leaves 4) 25% more than that in graduated leaves