Ques # :44 The size factor is employed to find out the endurance limit of a part from the endurance limit of the material (as determined from the standard rotating beam specimen). For sizes greater than 50 mm, this factor is 1) 0.85 2) 0.75 3) 0.9 4) 1.25
Asked in RPSC 02Jun 2016Question Paper for Asst. Engineer (Mechanical) GWD Screening Test - 2014ASST. ENGINEER - 2014
Answer under review: our editors are checking this question. Try the other RPSC Prelims previous year questions questions meanwhile.
More RPSC Prelims previous year questions questions
- Ques # :45 The shock and fatigue factors used in the design of shafts as per ASME for the case of gradually applied load are respectively 1) 1.0 and 1.0 2) 1.0 and 1.5 3) 1.25 and 1.0 4) 1.5 and 1.0
- Ques # :46 The bending stress in full length leaves of a laminated spring is 1) same as in graduated leaves 2) 50% more than that in graduated leaves 3) 50% less than that in graduated leaves 4) 25% more than that in graduated leaves
- A component has a cross section area of 100 mm² and section modulus of 5x10 mm³. It is subjected to an eccentric axial tensile load of 10 kN with an eccentricity of 10 mm. What will be the maximum and minimum stresses developed in the member?
- Which of the following is NOT the correct reason for using cast iron for components like machine bed, housings of gear boxes, etc.?
- Two beams of equal cross sectional area are subjected to same bending moment. The beam A is of solid circular section and the beam B is of square cross section. Which of these will be stronger in bending?
- What is the objective of tempering of steel after hardening?
- Pick the wrong statement about various theories of failure
- To take up limited mis-alignment of two coaxial shafts, which type of coupling is used?