Ques #:17 A slider crank mechanism with crank radius 60 mm is perpendicular to connecting rod having length 240 mm. The crank is rotating with uniform angular speed of 10 rad/s, counter clockwise. For the given configuration, the speed of slider is ____ m/s. 1) 618 2) 0.618 3) 6.18 4) 61.8
Asked in RPSC 02Jun 2016Question Paper for Asst. Drilling Engineer (Mines and Geology Deptt.) Screening Test- 2014ASST. DRILLING ENGINEER - 2014
Show answer
Answer: B. 0.618
More RPSC Prelims previous year questions questions
- For a certain engine having an average speed of 20 rps, a flywheel approximated as a solid disc, is required for keeping the fluctuation of the speed within 2% about the average speed. The fluctuation of kinetic energy per cycle is found to be 2kJ. What is the least possible mass of the flywheel if its diameter is not to exceed 1 m?
- In the figure shown, the spring deflects by δ to position A (the equilibrium position) when a mass m is at position B at some instant. The change in potential energy of the spring mass system from position A to position B is
- The vibration machine is isolated from floor using springs. If the ratio of excitation frequency of vibration of machine to the natural frequency of the isolation system is equal to 0.5, the transmissibility ratio of isolation is :-
- Ques # :24 In metals subjected to cold working, strain hardening effect is due to : 1) Slip mechanism 2) Twinning mechanism 3) Dislocation mechanism 4) Fracture mechanism
- Ques # :25 A steel bar of 5 mm is heated from 15 °C to 40 °C and it is free to expand. The bar will induce 1) No stress 2) Shear Stress 3) Tensile Stress 4) Compressive stress
- Ques # :26 Euler's critical load for a column with both ends hinged is found as 40 kN. What would be the change in the critical load if both ends are fixed? 1) 160 kN 2) 200 kN 3) 20 kN 4) 50 kN
- A solid circular shaft is subjected to a bending moment M and twisting moment T. What is the equivalent twisting moment Te which will produce the same maximum shear stress as the above combination? 1) M^2 + T^2 2) M+T 3) \sqrt{M^2 + T^2} 4) M-T
- Ques # :28 The shapes of the bending moment diagram for a uniform cantilever beam carrying a uniformly distributed load over its length is:- 1) A straight line 2) A hyperbola 3) An ellipse 4) A parabola