Ques #: 6 Tool life equation for tools under consideration are as follows- HSS: VT^0.2 = 150, Carbide: VT^0.3 = 250, where V is cutting speed in m/min and T is the tool life in min. The breakeven cutting speed above which the carbide tool will be beneficial is:- 1) 54 m/min 2) 150 m/min 3) 194 m/min 4) 250 m/min
Asked in RPSC 02Jun 2016Question Paper for Asst. Drilling Engineer (Mines and Geology Deptt.) Screening Test- 2014ASST. DRILLING ENGINEER - 2014
Show answer
Answer: C. 194 m/min
More RPSC Prelims previous year questions questions
- Ques #: 7 When the ordering cost is increased to 4 times,the Economic Order Quantity(EOQ) will be increased to : 1) 2 times 2) 3 times 3) 8 times 4) Remains same
- Ques #: 8 The time taken to drill a hole through a 25 mm thick plate with the drill rotating at 300 rpm and moving at a feed rate of 0.25 mm/rev is:- 1) 10 sec 2) 20 sec 3) 60 sec 4) 100 sec
- Ques #: 9 The method of classification of items to be adopted for spare parts inventory is : 1) ABC analysis 2) XYZ analysis 3) VED analysis 4) SDE analysis
- Ques #: 10 In rolling process, sheet of 25 mm thickness is rolled to 20 mm thickness. Roll is of diameter 600 mm and it rotates at 100 rpm. The rod strip contact length will be 1) 5 mm 2) 39 mm 3) 78 mm 4) 120 mm
- Ques #:11 Calculate the smallest punch diameter that can be designed for piercing sheet metal strip with the following data: [Crushing strength of the punch material is 1500 Mpa. Thickness of the sheet is 2mm, factor of safety is 3, and shear strength of the sheet material is 500 Mpa] 1) 2 mm 2) 6 mm 3) 8 mm 4) 24 mm
- Ques #:12 A shaft has diameter \(35_{-0.025}^{-0.009}\). The respective values of fundamental deviation and tolerance are :- 1) \(-0.025, \pm 0.008\) 2) \(-0.025, -0.008\) 3) \(-0.009, \pm 0.008\) 4) \(-0.009, 0.016\)
- Ques #:13 A taper hole is inspected using a CMM, with a probe of 2 mm diameter. At a height, Z=10 mm from the bottom, 5 points are touched and diameter of circle (not compensated for probe size) is obtained as 20 mm. Similarly, a 40 mm diameter at height Z= 40 mm, the smaller diameter (in mm) of the hole at Z=0 is 1) 13.334 2) 15.334 3) 15.442 4) 15.542
- Ques #:14 In a 2-D CAD package, clockwise circular are of radius 5,specified from P1(15,10) to P2(10,15) will have its centre at:- 1) (10,10) 2) (15,10) 3) (15,15) 4) (10,15)