Ques # :79 Interferometry is used to measure 1) Straightness 2) Flatness 3) Roundness 4) Angularity
Asked in RPSC 23Feb 2016Question Paper for VicePrincipal/Superintendent ITI Screening Test 2012(Mechanical Engineering)VICE PRINCIPAL/SUPDT. ITI - 2012
Show answer
Answer: B. Flatness
More RPSC Prelims previous year questions questions
- Ques # :80 The angle on which the strength of the tool depends is 1) Lip angle 2) Clearance angle 3) Rake angle 4) Cutting angle
- Ques # :81 The factor responsible for the formation of continuous chips with built up edge is 1) High cutting speed and large rake angle 2) High cutting speed and small rake angle 3) Low cutting speed and large rake angle 4) Low cutting speed and small rake angle
- Ques # :82 The interpolator in a CNC machine controls 1) Spindle Speed 2) Coolant flow 3) Feed rate 4) Tool change
- Ques # :83 Two and half axis control in NC machines means 1) Control of three axis simultaneously 2) Control of two axis and spindle speed simultaneously 3) Control of two axis simultaneously and one axis independently 4) Control of two axis simultaneously and one axis is stationary
- Ques # :84 Critical temperature is the temperature above which 1) A gas will never liquefy 2) A gas will immediately liquefy 3) Water will evaporate 4) Water will never evaporate
- Ques # :85 Time study of an operator with a performance rating of 120% yields a time of 2 minutes. If the allowances of 10% of total available time are to be given, then what is the Standard time of the operation. 1) 2.00 minutes 2) 2.40 minutes 3) 2.64 minutes 4) 2.67 minutes
- Ques # :86 Which one among the following is a 'THERBLIG' : 1) Get 2) Step 3) Put 4) Position
- Ques # :87 Work sampling is used to find 1) Percentage occurrence of certain activity 2) Rating of job 3) Pre-determined motion time data 4) Quality control of incoming inventory