Ques #:84 The slope of the bending moment diagram of any section of a loaded beam is :- 1) Torsion at the section. 2) Maximum shear force of the beam. 3) Shear force at that section. 4) Maximum bending moment of the beam.
Asked in RPSC 23Feb 2016Question Paper for VicePrincipal/Superintendent ITI Screening Test 2012(Civil Engineering)VICE PRINCIPAL/SUPDT. ITI - 2012
Show answer
Answer: C. Shear force at that section.
More RPSC Prelims previous year questions questions
- Ques #:85 In conjugate beam, the loading is equal to :- 1) Shear force diagram of actual beam 2) Bending moment diagram of actual beam 3) Loading of actual beam 4) M/EI diagram of actual beam
- Ques #:86 What kind of bending moments, (if any) are developed at the intermediate support of a continuous beam loaded by vertical loads :- 1) Hogging 2) Sagging 3) No moment 4) Mostly sagging, but sometimes zero.
- Ques #:87 Written below are same types of structures :- a) Beams b) Frames c) Trusses Miller - Breslau's principle is applicable to which types of strictures, select correct answer from the following :- 1) (a) only 2) (b) only 3) (a) and (b) only 4) (a) , (b) and (c)
- Ques #:88 Silt particle size as per unified soil classification system is :- 1) > 4.75 mm 2) 0.075 to 4.75 mm 3) 0.002 to 0.075 mm 4) < 0.002 mm
- Ques #:89 A sand sample of 25 cm length was subjected to a constant head permeability in a permeameter having an area of 30 cm\(^2\). A discharge of 120 cm\(^3\) was obtained in a period of 1 minute under a head of 40 cm. The coefficient of permeability is equal to :- 1) (1/240) cm/sec. 2) 2.4 cm/sec. 3) (1/24) cm/sec. 4) 24 cm/sec.
- Ques #:90 Which one of the following statements is incorrect is respect to shear strength of granular soils :- 1) It is affected largely by the initial void ratio. 2) It is not affected by the effective stresses. 3) The cohesion value of uncemented granular soil is approximately zero. 4) Undrained strength is insignificant except during the earthquake.
- Ques # :92 Which one of the following pairs is not correctly matched in context of IS456 provisions for reinforced concrete :- 1) Footing Design - Punching shear generally considered. 2) Concrete Cover - Essential for durability. 3) Beams are mostly - without shear reinforcement. 4) Roof slab design may be - Without shear reinforcement.
- Ques # :93 Side face reinforcement is required when the depth of beam is :- 1) Greater than 750 mm 2) Greater then 1000 mm 3) Greater then 300 mm 4) Greater then 500 mm