The current drawn by a DC motor is determined by the difference between the applied voltage and the back EMF, divided by the armature resistance. This difference in voltage is often referred to as the voltage drop across the armature resistance.
The current drawn by a 220 V DC motor of armature resistance 0.5 $\Omega$ and back e.m.f. 200 V is
Asked in GS&EI ElectEngg 14 2024 1601 2025 · Topic: Electric Current (Electromotive Force (EMF) and internal resistance of a cell)
More Physics questions
- If the dimensions of all parts of the synchronous generator and the number of field and the armature turns are doubled, then the generated voltage will change by a factor of
- Load frequency control is achieved by properly matching the individual machine's
- Series capacitive compensation in EHV transmission lines is used to
- The line constants of a 200 km, 3-$\phi$, 50 Hz transmission line are given as following : $A \angle 90^{\circ} \text{ S}/\text{phase}$ The sending-end voltage is 230 kV. The value of the line charging current, when the load is disconnected, will be
- The line constants of a 200 km, 3-φ, 50 Hz transmission line are given as following : A = D 0.001 ∠90° S/phase The sending-end voltage is 230 kV. The value of the line charging current, when the load is disconnected, will be
- A copper wire of radius r and length 1 has a resistance of R. A second copper wire with radius 2r and length 1 is taken and the two wires are joined in a parallel combination. The resultant resistance of the parallel combination of the two wires will be
- A wire of copper having length l and area of cross-section A is taken and a current I is flown through it. The power dissipated in the wire is P. If we take an aluminum wire having same dimensions and pass the same current through it, the power dissipated will be
- An electric circuit is consisting of a cell, an ammeter and a nichrome wire of length l. If the length of the wire is reduced to half (l/2), then the ammeter reading