The difference between the minimum and maximum permissible limits of the sizes is known as ______.
Asked in GPSC Assistant Regional Transport Officer / Assistant Director of Transport, Class-2, Ports and Transport Department 2025
Show answer
Answer: C. Tolerance
More GPSC Prelims previous year questions questions
- For a clearance fit, minimum clearance is the difference between ______ size of the hole and the ______ size of the shaft.
- Which of the following statements is true for mating parts allowance?
- The centroid is located vertically at a distance of ______ from the top line of the “T” section as shown in the figure given below.
- The centroid of a semicircle (radius = r) is located at a distance of ______ along the vertical radius from its center
- A triangular section has 5 cm base and 6 cm height. The moment of inertia of the section about the base is ______.
- Polar moment of inertia for an area with respect to an axis perpendicular to the plane is equal to ______.
- Identify the force system from the figure given below. F₁, F₂, F₃ are representing the forces.
- Two forces of magnitude P = 4 N and Q = 3 N are acting at a point O as shown in the figure given below. If the angle between the forces is 60°, then the magnitude of the resultant force ‘R’ is approximately ______.