Which one of the following is not a type of estimate used in electrical works?
Asked in APPSC (Arunachal) Question Booklet (Set-A) of Paper I and Paper II 2026
Show answer
Answer: D. Statistical estimate
More APPSC Prelims previous year questions questions
- Ferranti effect is observed in a transmission line when
- Consider the following statements : (i) Synchronous motor runs at constant speed independent of load. (ii) Induction motor’s speed varies with load. (iii) Single-phase motor has rotating magnetic field at start. (iv) Synchronous motor can operate at leading power factor. (v) Induction motor requires DC excitation. Correct statements are
- A single-phase full-wave mid-point thyristor converter uses a 230/200 V transformer with centre tap on the secondary side (100–0–100 V). The Peak Inverse Voltage (PIV) per thyristor is
- Potential transformers are used to measure
- In a hydroelectric power station, the function of the surge tank is to
- A voltage waveform is given by v(t) = [2√2 + 2sin(ωt) − 2sin(3ωt)] volts. This voltage is measured using a moving-coil voltmeter (reading V1) and a moving-iron voltmeter (reading V2). Then V1 and V2 values respectively are
- In a DC shunt motor, the torque is proportional to
- Overhead charges in an electrical estimate include (i) office rent and administrative expenses (ii) labour wages for wiring (iii) depreciation of tools and equipment (iv) cost of transportation of materials (v) contractor's profit From the above, the correct answer is [A] (i), (iii) and (iv) only [B] (i), (ii) and (iv) only [C] (i), (iii) and (v) only [D] (ii), (iii) and (iv) only