Consider the following statements about governors: Statement I: In a centrifugal governor, it is the radial (normal) component of the acceleration that is primarily responsible for creating the controlling force. Statement II: In an inertia shaft governor, radial component of acceleration is small and much less effective. Statement III: An inertia governor is less sensitive as compared with a centrifugal governor. Which of the above statements are correct?
Asked in GPSC Graduate Engineer Trainee, Class-2, Gujarat Maritime Board (GMB) 2026
Show answer
Answer: A. I and II only
More GPSC Prelims previous year questions questions
- Consider the following statements regarding Gruebler's criterion for planar mechanisms: Statement I: Gruebler's criterion is used in kinematics to determine the degrees of freedom of a planar mechanism. Statement II: For a planar mechanism, Gruebler's criterion is defined as F = 3(n–1) – 2j1 – j2, Where F is degrees of freedom, n is total number of links in the mechanism, j1 is number of lower pairs and j2 is number of higher pairs. Statement III: A planar four-bar mechanism has two degrees of freedom. Which of the above statements are correct?
- Consider the following statements regarding cam pairs and degrees of freedom: Statement I: A cam pair has two degrees of freedom. Statement II: A cam pair can be replaced by one binary link with two turning pairs at each end. Statement III: To have one cam pair in a mechanism with one degree of freedom, if the mechanism has three links, then turning pairs should be two. Statement IV: To have one cam pair in a mechanism with one degree of freedom, if the mechanism has three links, then turning pairs should be five. Which of the above statements are correct?
- Consider the following statements regarding chaplets used in casting: Statement I: The main objective of chaplets is to impart good alignment of mould and core surfaces and to achieve directional solidification. Statement II: The chaplets are generally made of parent metal of which the casting is. Statement III: When the molten metal is poured in the mould cavity, the chaplet melts and fuses itself along with molten metal during solidification and thus forms a part of the cast material. Which of the above statements are correct?
- A specimen of 100 mm length is machined on a shaper using a tool with a 15° rake angle. The uncut chip thickness is 1.5 mm and the chip length obtained is 40 mm. The shear plane angle is approximately
- For orthogonal metal cutting, the chip velocity (Vc ) and shear velocity (Vs ) in terms of cutting velocity V, rake angle (α) and shear angle (ϕ) is given by
- A cutting tool operates at a cutting speed of 160 m/min and gives a tool life of 5 minutes. The Taylor's tool life constant is 229. The value of the tool life exponent is approximately
- Consider the following statements regarding Numerical Control (NC): Statement I: NC machines resulting in shorter cycle times as compared with manually operated machine tools. Statement II: NC machines reduce manufacturing lead time than manually operated machine tools. Statement III: The first widely used part programming language for NC machines was APT (Automatically Programmed Tooling). Statement IV: The only disadvantage is that NC machines generally require more complex fixturing than conventional machine tools. Which of the above statements are correct?
- Consider the following statements regarding ABC Analysis: Statement I: A type of items, approximately are about 10 % in number and account for around 75 % of the annual inventory usage value. Statement II: B type of items, approximately are about 20 % in number and account for around 15 % of the annual inventory usage value. Statement III: C type of items, approximately are about 70 % in number and account for around 10 % of the annual inventory usage value. Which of the above statements are correct?