Consider the following statements regarding balancing in linkages: Statement I: Balancing in linkages directly addresses balancing the shaking force only. Statement II: Force balancing a linkage is directly related to the position of the total center of mass. Statement III: The method of static balancing, in which concentrated link masses are replaced by systems of masses that are statically equivalent. Which of the above statements are correct?
Asked in GPSC Graduate Engineer Trainee, Class-2, Gujarat Maritime Board (GMB) 2026
Show answer
Answer: B. II and III only
More GPSC Prelims previous year questions questions
- Consider the following statements about governors: Statement I: In a centrifugal governor, it is the radial (normal) component of the acceleration that is primarily responsible for creating the controlling force. Statement II: In an inertia shaft governor, radial component of acceleration is small and much less effective. Statement III: An inertia governor is less sensitive as compared with a centrifugal governor. Which of the above statements are correct?
- Consider the following statements regarding Gruebler's criterion for planar mechanisms: Statement I: Gruebler's criterion is used in kinematics to determine the degrees of freedom of a planar mechanism. Statement II: For a planar mechanism, Gruebler's criterion is defined as F = 3(n–1) – 2j1 – j2, Where F is degrees of freedom, n is total number of links in the mechanism, j1 is number of lower pairs and j2 is number of higher pairs. Statement III: A planar four-bar mechanism has two degrees of freedom. Which of the above statements are correct?
- Consider the following statements regarding cam pairs and degrees of freedom: Statement I: A cam pair has two degrees of freedom. Statement II: A cam pair can be replaced by one binary link with two turning pairs at each end. Statement III: To have one cam pair in a mechanism with one degree of freedom, if the mechanism has three links, then turning pairs should be two. Statement IV: To have one cam pair in a mechanism with one degree of freedom, if the mechanism has three links, then turning pairs should be five. Which of the above statements are correct?
- Consider the following statements regarding chaplets used in casting: Statement I: The main objective of chaplets is to impart good alignment of mould and core surfaces and to achieve directional solidification. Statement II: The chaplets are generally made of parent metal of which the casting is. Statement III: When the molten metal is poured in the mould cavity, the chaplet melts and fuses itself along with molten metal during solidification and thus forms a part of the cast material. Which of the above statements are correct?
- A specimen of 100 mm length is machined on a shaper using a tool with a 15° rake angle. The uncut chip thickness is 1.5 mm and the chip length obtained is 40 mm. The shear plane angle is approximately
- For orthogonal metal cutting, the chip velocity (Vc ) and shear velocity (Vs ) in terms of cutting velocity V, rake angle (α) and shear angle (ϕ) is given by
- A cutting tool operates at a cutting speed of 160 m/min and gives a tool life of 5 minutes. The Taylor's tool life constant is 229. The value of the tool life exponent is approximately
- Consider the following statements regarding Numerical Control (NC): Statement I: NC machines resulting in shorter cycle times as compared with manually operated machine tools. Statement II: NC machines reduce manufacturing lead time than manually operated machine tools. Statement III: The first widely used part programming language for NC machines was APT (Automatically Programmed Tooling). Statement IV: The only disadvantage is that NC machines generally require more complex fixturing than conventional machine tools. Which of the above statements are correct?