Consider the following statements regarding herringbone gears: Statement I: A herringbone gear comprises teeth having both right- and left-hand helix cut on the same gear blank. Statement II: The axial force of the right-hand half of the herringbone gear is balanced by that of the left-hand half. Statement III: For the efficient transmission of large amounts of power at high speeds, herringbone gears are almost universally employed. Statement IV: Helix angles are usually larger for herringbone gears than for single-helical gears.
Asked in GPSC Graduate Engineer Trainee, Class-2, Gujarat Maritime Board (GMB) 2026
Show answer
Answer: D. I, II, III and IV
More GPSC Prelims previous year questions questions
- Consider the following statements regarding balancing in linkages: Statement I: Balancing in linkages directly addresses balancing the shaking force only. Statement II: Force balancing a linkage is directly related to the position of the total center of mass. Statement III: The method of static balancing, in which concentrated link masses are replaced by systems of masses that are statically equivalent. Which of the above statements are correct?
- Consider the following statements about governors: Statement I: In a centrifugal governor, it is the radial (normal) component of the acceleration that is primarily responsible for creating the controlling force. Statement II: In an inertia shaft governor, radial component of acceleration is small and much less effective. Statement III: An inertia governor is less sensitive as compared with a centrifugal governor. Which of the above statements are correct?
- Consider the following statements regarding Gruebler's criterion for planar mechanisms: Statement I: Gruebler's criterion is used in kinematics to determine the degrees of freedom of a planar mechanism. Statement II: For a planar mechanism, Gruebler's criterion is defined as F = 3(n–1) – 2j1 – j2, Where F is degrees of freedom, n is total number of links in the mechanism, j1 is number of lower pairs and j2 is number of higher pairs. Statement III: A planar four-bar mechanism has two degrees of freedom. Which of the above statements are correct?
- Consider the following statements regarding cam pairs and degrees of freedom: Statement I: A cam pair has two degrees of freedom. Statement II: A cam pair can be replaced by one binary link with two turning pairs at each end. Statement III: To have one cam pair in a mechanism with one degree of freedom, if the mechanism has three links, then turning pairs should be two. Statement IV: To have one cam pair in a mechanism with one degree of freedom, if the mechanism has three links, then turning pairs should be five. Which of the above statements are correct?
- Consider the following statements regarding chaplets used in casting: Statement I: The main objective of chaplets is to impart good alignment of mould and core surfaces and to achieve directional solidification. Statement II: The chaplets are generally made of parent metal of which the casting is. Statement III: When the molten metal is poured in the mould cavity, the chaplet melts and fuses itself along with molten metal during solidification and thus forms a part of the cast material. Which of the above statements are correct?
- A specimen of 100 mm length is machined on a shaper using a tool with a 15° rake angle. The uncut chip thickness is 1.5 mm and the chip length obtained is 40 mm. The shear plane angle is approximately
- For orthogonal metal cutting, the chip velocity (Vc ) and shear velocity (Vs ) in terms of cutting velocity V, rake angle (α) and shear angle (ϕ) is given by
- A cutting tool operates at a cutting speed of 160 m/min and gives a tool life of 5 minutes. The Taylor's tool life constant is 229. The value of the tool life exponent is approximately