Match the following: List-I List-II 1. Clausius statement (a) Heat engine 2. Kelvin-Planck statement (b) Refrigerator 3. PMM-I (c) Violates second law of thermodynamics 4. PMM-II (d) Violates first law of thermodynamics The correct match is:
Asked in GPSC Graduate Engineer Trainee, Class-2, Gujarat Maritime Board (GMB) 2026
Show answer
Answer: B. 1 – b, 2 – a, 3 – d, 4 – c
This previous-year question came without the commission's answer key; the answer was checked by AI. Always confirm with the official key.
More GPSC Prelims previous year questions questions
- The percentage change in volume of a steel bar (Modulus of Elasticity = 205 GPa, Poisson's ratio = 0.3) of 20 mm diameter and 600 mm length when a tensile stress of 180 MPa is applied along its longitudinal axis
- Consider the following statements: Statement I: For a cantilever beam carrying a uniformly varying load (UVL), the shear force diagram is parabolic. Statement II: For a cantilever beam carrying a uniformly varying load (UVL), the bending moment diagram is cubic. Which of the following is correct?
- A long rod of uniform rectangular section is bent to form a circular arc. The thickness of the section is t, length of the rod is l and the displacement of the midpoint is d (where d ≪ l). The maximum longitudinal strain developed in the rod is:
- Consider the following statements for a cantilever beam carrying a point load W at the free end: Statement I: Maximum bending moment occurs at the fixed end. Statement II: Maximum deflection occurs at the free end. Statement III: Slope at the free end is WL2/3E . Statement IV: Deflection at the free end is WL3/2EI . Which of the above statements are correct?
- Consider the following statements regarding a circular shaft (G = Shear Modulus of the material, J = Polar Moment of Area, T = Applied Torque, θ = Angle of Twist, L = Length of the shaft): Statement I: Torsional rigidity of a shaft is given by GJ. Statement II: Torsional stiffness of a shaft is given by GJ/L . Statement III: Torsional stiffness of a shaft is equal to T/θ. Which of the above statements are correct?
- Consider the following statements: Statement I: Tendency of knock increases with advanced spark timing. Statement II: Advanced spark timing increases the pressure and temperature of the unburnt end-gas, promoting its auto-ignition. The correct option is
- In an Otto cycle, air at 15°C and 1.05 bar is compressed adiabatically until the pressure reaches 13 bar. The specific heat ratio of air is γ=1.4. Consider the following statements: Statement I: The compression ratio of the cycle is approximately 6.04. Statement II: The air-standard efficiency of the cycle is approximately 51.3%. Statement III: The compression ratio of the cycle is less than 7. Statement IV: Increasing the compression ratio increases the air-standard efficiency of an Otto cycle. Which of the above statements are correct?
- Consider the following statements regarding combustion in SI engines: Statement I: The higher the self-ignition temperature of the fuel, the longer the ignition lag. Statement II: The ignition lag is smallest for the mixture ratio that gives the maximum temperature. Statement III: The ignition lag depends on the chemical nature of the fuel. Which of the above statements are correct?