A single-point turning operation is considered orthogonal cutting, if
Asked in APPSC (Arunachal) Question Booklet (Set-A) of Paper I and Paper II 2026
Show answer
Answer: A. rake face perpendicular to cutting velocity, edge parallel to motion
More APPSC Prelims previous year questions questions
- The correct sequence of tool materials in increasing order of increasing hot hardness is
- A lathe operation has main cutting force Fc = 400 N, Workpiece speed = 50 m/min. Power required (W) is approximately
- A lathe reduces diameter 60 → 54 mm, length = 300 mm, feed = 0.2 mm/rev, spindle = 150 rpm. Cutting time (min) is
- In machining mild steel with carbide tool (n = 0.2), if cutting speed is doubled, tool life will approximately become
- For ceramic tool (n = 0.15), at V1 = 300 m/min, T1 = 45 min. What speed of V2 gives T2 = 15 min?
- For finishing operations, tool life is frequently limited by
- In a taper turning process performed in a lathe, if D = large diameter and d = small diameter and l = length of the job, then tangent of half of the taper angle is
- The process of removing metal by rotating cutter, which is rotated in a direction opposite to the table feed direction, is known as