For finishing operations, tool life is frequently limited by
Asked in APPSC (Arunachal) Question Booklet (Set-A) of Paper I and Paper II 2026
Show answer
Answer: B. surface roughness requirement (e.g., Ra > 1.6 µm)
More APPSC Prelims previous year questions questions
- In a taper turning process performed in a lathe, if D = large diameter and d = small diameter and l = length of the job, then tangent of half of the taper angle is
- The process of removing metal by rotating cutter, which is rotated in a direction opposite to the table feed direction, is known as
- ______ is the operation used for making a conical chamfer on the edge of the hole.
- Which of the following is a kinematic pair mismatch in machine tool motions?
- In a milling process, an HSS cutter of 120 mm diameter with 8 number of teeth is used to mill a component. If the cutting speed is 24 m/min and table feed rate is 0.12 mm/tooth, the time required to complete the machining length of 115 mm is
- Choose the wrong statement.
- A mild steel rod 300 mm long, 25 mm diameter is to be turned to reduce its diameter to 24 mm in one cut. If the rod is rotating at 510 rpm, the cutting speed would be equal to
- Knurling operation on lathe is used for