In the given force equation for the system, M d²(y-x)/dt² + f dy/dt + ky = 0, if α- constant acceleration is applied to the accelerometer then the steady-state displacement 'y' is a measure of
Asked in TNPSC Industrial Safety and Health (Subject Code 515)
Show answer
Answer: A. constant input acceleration
More TNPSC Prelims previous year questions questions
- The acquisition time in sample-hold characteristics of data acquisition system is time required
- In Data Acquisition System, if in pre-amplification circuit, signal levels below a tenth of an mV is needed than the following is used :
- What is the bandwidth required for an F.M. signal in which the modulating frequency is 2 kHz and maximum deviation is 10 kHz?
- A linear displacement transducer (digital) normally uses
- Piezoelectric transducer cannot measure ________ pressure.
- In a transducer, the observed output deviates from the correct value by a constant factor the resulting error is called
- Calculate the sensitivity of a 200 μA meter movement which is to be used as a dc voltmeter. (A) 5kΩ/V (B) 200 kΩ/V (C) 50 kΩ/V (D) 150 kΩ/V (E) Answer not known
- A gear wheel having 60 teeth is mounted on a shaft running of 1800 rpm drives a gear having 30 teeth through two carriers 120 teeth and 60 teeth. The 30 teeth gear drives a double worm which is mounted on a shaft. Find the speed of the last shaft. (A) 900 rpm (B) 1800 rpm (C) 3600 rpm (D) 7200 rpm (E) Answer not known
All 17,524 TNPSC Prelims previous year questions questions →